The Fascia Gutter Hanger with Tab is designed for installation on vertical (plumb) fascia boards, providing exceptional strength and a clean, consistent gutter profile. Manufactured from heavy-gauge steel, this hanger follows the gutter closely while keeping it slightly off the fascia to allow airflow behind the system.

The exterior hanger design helps the fascia board breathe and dry out, reducing the risk of moisture-related damage over time. Integrated tabs make this hanger especially well suited for new construction, remodeling, and renovation work, allowing for easier alignment and secure placement during installation.

This hanger can also be used on fascia boards that are 90 to the roof pitch. If needed, the short tail of the hanger can be bent to accommodate roof slopes up to 12/12 pitch. On longer runs, installers should account for the gutter moving slightly closer to the siding as slope is introduced.

Tested and approved to EN 1462:2005, this fascia hanger meets the highest load classification (Class H 750 N) for reliable performance under snow, ice, and heavy water loads. Installation requires two exterior-grade or stainless steel fasteners per hanger. Recommended spacing is one hanger every 2 feet of gutter.

Key Features