Fasco A249 1 Speed 3400 RPM Draft Inducer Blower Motor (115V)

The Fasco A249 1 Speed 3400 RPM Draft Inducer Blower Motor (115V) is a Fasco blower motor for HVAC repair and replacement work. Use it when the part number A249 and the listed specifications match the equipment being serviced.

Note: This is an aftermarket replacement part, please confirm compatibility with your original manufacturer part number Fasco Round Outlet Shaded Pole Draft Inducer Blower, 115 Volts Features: OEM Direct Replacement – Draft Inducer Blower 3.3″ Diameter Shaded Pole Thermally Protected Open Air Over Class B Insulation, 40C Ambient Ball Bearing 8″ Leads with Pin Terminal Housing OEM Model Draft Inducer Replacement: Lennox 103618-01 Lennox 103618-03 Fasco 702112686 Fasco 702113118

Key Specs

• Type: Shaded Pole
• Voltage: 115V
• RPM: 3400
• Phase: 1
• Speeds: 1
• Product Type: Blower Motor

Expert Verdict

Reviewed by the SuperArbor Pro Desk: choose this part when the existing component label and unit documentation match A249 and the spec set above. It is best suited for targeted HVAC service repairs where exact fitment matters more than broad universal compatibility.

FAQs

What is the Fasco A249 used for?

It is a blower motor for compatible Fasco HVAC equipment. Match the part number A249 and the equipment service literature before ordering or installing.

Which specs should I verify before purchase?

Verify the spec set shown for this part: Type: Shaded Pole; Voltage: 115V; RPM: 3400; Phase: 1; Speeds: 1; Product Type: Blower Motor. The replacement should match the existing component and the unit documentation.

Does the electrical rating need to match exactly?

Yes. Confirm voltage rating 115V against the failed component label. Do not substitute a different rating unless the equipment manufacturer allows it.

Is this an OEM-style replacement part?

Use it as a direct replacement only when Fasco documentation lists A249 or an approved equivalent for the unit being serviced.

Who should install this HVAC component?

A qualified HVAC technician should install and test the blower motor. Disconnect power first, follow lockout procedures, and confirm safe operation after replacement.

Safety and Installation Notes

Disconnect power before service. HVAC electrical and combustion-related components should be installed and tested by a qualified technician. After installation, confirm wiring, mounting, airflow or fluid routing as applicable, and normal system operation.